Sensor not showing as online.¶
Determining Online Status¶
It is important to note that the online marker in the Web UI does not display real-time information. Instead it refreshes its status between every 30 seconds to every few minutes depending on the page in question.
This means that an icon showing a sensor is not online may be lagging behind the actual status. If you need to get a positive feedback on whether the sensor is online or not, go to the "Sensors" page which refreshes status more often, moving to the "Sensors" page also triggers a refresh of the status right away.
Reasons for Temporary Disconnect¶
Sensors connect to the cloud via a semi-persistent SSL connection. In general, if a host has connectivity to the internet, the sensor should be online. There are, however a few situations that result in the sensor temporarily disconnecting from the cloud for a few seconds. This means that if you temporarily see a sensor as offline when you expect it to be online, give it 30 seconds, in most situations it will come back online with 5 seconds.
- Make sure the sensor is actually offline by refreshing the Sensors page on the Web UI.
- Wait 30 seconds and refresh the page again, to make sure the sensor was not momentarily reconnecting.
- Check to see if the LimaCharlie service is running on the host.
- On Windows, go to the Services control panel and check the status of the LimaCharlie service.
- On MacOS, open the Activity Monitor application, make sure to select "Show All Processes" and look for the
- On Linux, in a terminal issue
ps -elf | grep rphcp.
- If the service is not running, restart it. If you're not sure how to do it, a restart of the host will also work.
If these steps do not help, get in touch with us, we will help you figure out the issue. The best way of contacting us
is via our Community Slack Channel, followed by
Sensor not Connecting¶
Sensors connect to the LimaCharlie.io cloud via an SSL connection on port 443. Make sure your network allows such a connection. It is a VERY common port usually used for HTTPS so an issue is highly unlikely.
The sensor uses a pinned SSL certificate to talk to the cloud. This means that if you are in a network that enforces SSL introspection (a man- in-the-middle of the SSL connections sometimes used in large corporate environments), this may prevent the sensor from connecting. LimaCharlie uses a pinned certificate to ensure the highest level of security possible as usage of off-the-shelf certificates can be leveraged by state sponsored (or advanced) attackers.
If your network uses SSL introspection, we recommend you setup an exception for the LimaCharlie cloud domain relevant to you. Get in touch with us and we can provide you with the necessary information.